92 4.0 accel studder and intake backfire
#1
Member
Thread Starter
Join Date: Mar 2010
Location: Colorado
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0L
92 4.0 accel studder and intake backfire
Hi all, I have a 92 Cherokee sport 200k mi 5 speed. Recently I have noticed a slight studder under acceleration anywhere from 25 mph all the way to 75 mph. It happens most around 45 mph. Also sometimes when the studder occurs I get a backfire through the intake. I have replaced my fuel pump and filter. I have under 5k miles on new plugs and wires. I just cleaned up the cap an rotor as well. I have good fuel pressure. Anyone know what could be causing this problem? As an added note...the jeep feels very sluggish and does not feel like it has the power it use to have.
#2
Member
Thread Starter
Join Date: Mar 2010
Location: Colorado
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0L
Originally Posted by 92jeepxj
Hi all, I have a 92 Cherokee sport 200k mi 5 speed. Recently I have noticed a slight studder under acceleration anywhere from 25 mph all the way to 75 mph. It happens most around 45 mph. Also sometimes when the studder occurs I get a backfire through the intake. I have replaced my fuel pump and filter. I have under 5k miles on new plugs and wires. I just cleaned up the cap an rotor as well. I have good fuel pressure. Anyone know what could be causing this problem? As an added note...the jeep feels very sluggish and does not feel like it has the power it use to have.
Trending Topics
#12
CF Veteran
Join Date: Feb 2010
Location: Oroville, CA
Posts: 12,367
Likes: 0
Received 19 Likes
on
18 Posts
Year: 1995
Model: Grand Cherokee
Engine: 4.0 with all of the noise and clatter
You may have a plug wire or boot letting the spark leak out, could have carbon tracking inside the dist cap, or could have a couple wires cross firing. The timing should be ok if you never dinked with the distrbutor, and a jumped chain would cause a problem at any RPM if the engine even started.
#13
Member
Thread Starter
Join Date: Mar 2010
Location: Colorado
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0L
I went out at 1 this morning to the darkest back road I could find. Turned my lights off and opened the hood...no spark jumping at all. I also pulled the plugs one at a time to check engine idle and speed...all were good. Also I just cleaned out the distributor and rotor (cleaned the wear off the points). Could this be an O2 sensor problem?
#14
CF Veteran
Join Date: Nov 2010
Location: In the middle of Minnesota!
Posts: 5,805
Received 99 Likes
on
88 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
A backfire occurs when there is an imbalance in the air to fuel ratio required for your vehicle to operate properly. Yes, a lean condition can cause backfires in the intake.
Unless you have verified fuel pressure with a gauge, you're guessing if you have proper fuel delivery. Regulator still in play here. Be sure that your pressure is within factory SPEC. A gauge is the only way to be sure you're not chasing your tail here.
The backfire solution usually involves checking for vacuum leaks, and ensuring the fuel system is functioning properly.
Other things to consider if you have no vacuum leaks and fuel delivery is within spec: Ensure that your ignition is solid. You mention new plugs and wires and that you cleaned the cap and rotor. I would replace the cap and rotor. They aren't designed to be cleaned, and aren't expensive to replace. They can have cracks in them that you can't possibly see. Oxygen sensor can be responsible as well if they fail in a certain way. They have a finite lifespan between 100k and 150k, depending on the efficiency of the engine.
Unless you have verified fuel pressure with a gauge, you're guessing if you have proper fuel delivery. Regulator still in play here. Be sure that your pressure is within factory SPEC. A gauge is the only way to be sure you're not chasing your tail here.
The backfire solution usually involves checking for vacuum leaks, and ensuring the fuel system is functioning properly.
Other things to consider if you have no vacuum leaks and fuel delivery is within spec: Ensure that your ignition is solid. You mention new plugs and wires and that you cleaned the cap and rotor. I would replace the cap and rotor. They aren't designed to be cleaned, and aren't expensive to replace. They can have cracks in them that you can't possibly see. Oxygen sensor can be responsible as well if they fail in a certain way. They have a finite lifespan between 100k and 150k, depending on the efficiency of the engine.
Last edited by tjwalker; 05-09-2011 at 06:40 AM.
#15
Member
Thread Starter
Join Date: Mar 2010
Location: Colorado
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0L
Well I unplugged my o2 sensor for the drives today and it actually drove fine! No sluggishness and no stuttering at all. So should I automatically point my finger at the o2 sensor?