Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here XJ (84-01)
All OEM related XJ specific tech. Examples, no start, general maintenance or anything that's stock.

Going into 4 wheel drive

Old 02-17-2011, 10:42 PM
  #1  
Senior Member
Thread Starter
 
xj guy's Avatar
 
Join Date: Jan 2011
Location: Joliet, Il
Posts: 730
Likes: 0
Received 2 Likes on 2 Posts
Year: 1996
Model: Cherokee
Engine: HO4.0 I6
Default Going into 4 wheel drive

I have always just thrown it into park and then changed into four wheel drive. But just read in a thread that they just shift into neutral (while at a stop) and pull the lever? Is this how everyone goes about it? Iv'e never really asked or been told. And also please don't rip on me for asking, I'm still a total n00b when it comes to understanding how all the components of my Jeep work.
Old 02-17-2011, 10:44 PM
  #2  
Member
 
billfrank85's Avatar
 
Join Date: Sep 2010
Location: Grand Rapids, MI
Posts: 234
Likes: 0
Received 1 Like on 1 Post
Year: 1994
Model: Cherokee
Engine: 4.0
Default

I believe with the part-time 4WD system it is safe to shift "on the fly" into 4HI up to either 25 or 45 MPH (someone please feel free to correct me). I pop it into 4HI when driving into my snow/ice packed driveway (or mud since it all melted) with no problems.
Old 02-17-2011, 11:00 PM
  #3  
Senior Member
 
Fsher21's Avatar
 
Join Date: May 2010
Location: MI 48642
Posts: 882
Likes: 0
Received 1 Like on 1 Post
Year: 1996
Model: Cherokee
Engine: 4.0
Default

yeah you can shift on the fly. Just make sure you aren't turning and dont have your foot on the gas.
Old 02-17-2011, 11:00 PM
  #4  
Junior Member
 
4SFED's Avatar
 
Join Date: Feb 2011
Location: Michigan
Posts: 88
Likes: 0
Received 0 Likes on 0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0L
Default

I've never worried about shifting into 4HI at any speed lower than 50mph or so.... 4LOW is where I stop, shift trans to neutral, then shift diff lever to N (wait a second), then to 4LOW.

Last edited by 4SFED; 02-17-2011 at 11:26 PM.
Old 02-17-2011, 11:01 PM
  #5  
CF Veteran
 
mrfajita's Avatar
 
Join Date: May 2010
Location: Fort Collins, CO
Posts: 3,405
Likes: 0
Received 2 Likes on 2 Posts
Year: 1996
Model: Cherokee
Engine: 4.0L HO
Default

I throw mine into neutral. Ground it a few times but nothing major, but only with it in drive. never ground it in N
Old 02-17-2011, 11:04 PM
  #6  
Senior Member
Thread Starter
 
xj guy's Avatar
 
Join Date: Jan 2011
Location: Joliet, Il
Posts: 730
Likes: 0
Received 2 Likes on 2 Posts
Year: 1996
Model: Cherokee
Engine: HO4.0 I6
Default

Also, another thing. I know my 4x4 works and can tell but my 4x4 lights don't engage any more? Do you guys know where I can trouble shoot this with out pulling the dash?
Old 02-17-2011, 11:06 PM
  #7  
Senior Member
 
Fsher21's Avatar
 
Join Date: May 2010
Location: MI 48642
Posts: 882
Likes: 0
Received 1 Like on 1 Post
Year: 1996
Model: Cherokee
Engine: 4.0
Default

haha i didn't even know there was a 4x4 light, seems I need to get my bulb replaced too
Old 02-17-2011, 11:09 PM
  #8  
Senior Member
Thread Starter
 
xj guy's Avatar
 
Join Date: Jan 2011
Location: Joliet, Il
Posts: 730
Likes: 0
Received 2 Likes on 2 Posts
Year: 1996
Model: Cherokee
Engine: HO4.0 I6
Default

well it doesn't say 4x4. If I remember correctly it has
Full-time
Part-time
and then I also think it has a hi and lo light? not exactly sure can anyone back me up?

But none of these lights work on my Xj. They did at one point but they don't anymore, anyone have an idea?
Old 02-17-2011, 11:14 PM
  #9  
Senior Member
 
Fsher21's Avatar
 
Join Date: May 2010
Location: MI 48642
Posts: 882
Likes: 0
Received 1 Like on 1 Post
Year: 1996
Model: Cherokee
Engine: 4.0
Default

my 96' doesnt have part time or full time, did they come with more than one option for the transfer case?
Old 02-17-2011, 11:23 PM
  #10  
Senior Member
Thread Starter
 
xj guy's Avatar
 
Join Date: Jan 2011
Location: Joliet, Il
Posts: 730
Likes: 0
Received 2 Likes on 2 Posts
Year: 1996
Model: Cherokee
Engine: HO4.0 I6
Default

I wouldn't be the guy to ask. Tomorrow I'll look at it and see what I can see through the darkness. But I am almost positive it was full time part time. Although I may be confusing my past '88 and '89 XJ's but this one is a 96 sport. what model is your 96?
Old 02-17-2011, 11:26 PM
  #11  
Senior Member
 
Fsher21's Avatar
 
Join Date: May 2010
Location: MI 48642
Posts: 882
Likes: 0
Received 1 Like on 1 Post
Year: 1996
Model: Cherokee
Engine: 4.0
Default

sport. All you should have is the 4hi and 4lo. You don't want to be running that on pavement, wet or dry.
Old 02-17-2011, 11:53 PM
  #12  
Seasoned Member
 
XJJeff's Avatar
 
Join Date: Jan 2011
Location: NJ
Posts: 434
Likes: 0
Received 0 Likes on 0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0 I6 Powertech
Default

Yea the sport you can be rolling in drive up to 45 mph but at the part why anyway if your spinning stuck don't go ok and throw in 4hi some noises may occur like a waring label for a hot pocket for putting in the microwave to long. To disengage I usaly roll about 5mph in N shift from 4 high to 2wd for a couple of feet throw in drive I feel the bump to kick out and I am good to go no grinding gears. If I use 4lo I stop put foot on the break shift to 4hi then repeat steps above.
Old 02-18-2011, 12:08 AM
  #13  
CF Veteran
 
1996XJSport's Avatar
 
Join Date: Sep 2010
Location: West Bloomfield,MI
Posts: 1,992
Likes: 0
Received 0 Likes on 0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0L, CAI, Edelbrock Breather, Optima Yellowtop
Default

Originally Posted by xj guy
I have always just thrown it into park and then changed into four wheel drive. But just read in a thread that they just shift into neutral (while at a stop) and pull the lever? Is this how everyone goes about it? Iv'e never really asked or been told. And also please don't rip on me for asking, I'm still a total n00b when it comes to understanding how all the components of my Jeep work.
I think you can really do it either way... Personally, I like to put it into neutral and then shift my transfer case to 4HI. By doing this method you can actually shift from 2wd to 4hi while moving as long as you're under 35mph. Shifting into 4lo is completely different however. To properly execute a 4lo shift; you need to put the transmission into neutral and come to a dead stop. With the brake applied, go ahead and shift into 4lo. Then you're all good!
Old 02-18-2011, 12:09 AM
  #14  
CF Veteran
 
1996XJSport's Avatar
 
Join Date: Sep 2010
Location: West Bloomfield,MI
Posts: 1,992
Likes: 0
Received 0 Likes on 0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0L, CAI, Edelbrock Breather, Optima Yellowtop
Default

Originally Posted by billfrank85
I believe with the part-time 4WD system it is safe to shift "on the fly" into 4HI up to either 25 or 45 MPH (someone please feel free to correct me). I pop it into 4HI when driving into my snow/ice packed driveway (or mud since it all melted) with no problems.
almost right haha it's 35mph according to the 96 owner's manual
Old 02-18-2011, 02:07 AM
  #15  
Seasoned Member
 
98 XJS's Avatar
 
Join Date: Jan 2011
Location: Las Vegas, NV
Posts: 251
Likes: 0
Received 0 Likes on 0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0L
Default

I was wondering how everyone does it myself. Took her out for the first off road outing today, nothing major, just light trail and some hill climbs so I could test 4lo

When I had my JK the owners manual had a section an inch thick with about 497 steps/cautions about shifting into 4wd. I agree with the above and this is what I do: 4hi just shift on the fly, usually below 25 and for 4lo I drop into neutral, brake, shift t case, drop trans back into drive and go, reverse procedure for going back to 2wd

Thread Tools
Search this Thread
Quick Reply: Going into 4 wheel drive



All times are GMT -5. The time now is 08:13 PM.