Remote Starter Install. Help!?
01-15-2010, 05:04 AM
#1
Member
Thread Starter
Join Date: Sep 2009
Location: NJ
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: I6 4.0
Remote Starter Install. Help!?
I got a cheap Ultra Starter from my friend.
It comes with the alarm speaker, a few wire harnesses, and the control module.
Where the hell do I start? I'm not goin to waste my money and time with a worthless dealer so any help would be great. Tomorrow I start trying......
Anyone installed anything like this themselves?
It comes with the alarm speaker, a few wire harnesses, and the control module.
Where the hell do I start? I'm not goin to waste my money and time with a worthless dealer so any help would be great. Tomorrow I start trying......
Anyone installed anything like this themselves?
01-15-2010, 07:36 AM
#2
Senior Member
Join Date: Mar 2009
Location: Grand Rapids, Michigan
Posts: 554
Likes: 0
Received 1 Like
on
1 Post
Year: 2000
Model: Cherokee
Engine: 4.0
Well your going to need a power and a ground. So you could start there.
The one I had actually had 2 wires going to the power.
Then your ignition wire (ignition switch), and the application wire that goes to the climate control.
It really all depends on what brand and model you get.
If all else fails, you could read the directions.
The one I had actually had 2 wires going to the power.
Then your ignition wire (ignition switch), and the application wire that goes to the climate control.
It really all depends on what brand and model you get.
If all else fails, you could read the directions.
01-17-2010, 01:34 AM
#3
Member
Thread Starter
Join Date: Sep 2009
Location: NJ
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: I6 4.0
Well your going to need a power and a ground. So you could start there.
The one I had actually had 2 wires going to the power.
Then your ignition wire (ignition switch), and the application wire that goes to the climate control.
It really all depends on what brand and model you get.
If all else fails, you could read the directions.
The one I had actually had 2 wires going to the power.
Then your ignition wire (ignition switch), and the application wire that goes to the climate control.
It really all depends on what brand and model you get.
If all else fails, you could read the directions.
I'm sure it can't be that hard lol.......right?
01-17-2010, 01:37 AM
#4
CF Veteran
Join Date: Dec 2009
Location: Oxford NC
Posts: 1,882
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0L
nahhhhh it's never hard... till you accualy start doing it haha. same thing everyone said about coil spacers.. oh its no big deal but LCA bolts are a PITA
01-17-2010, 01:43 AM
#5
Member
Thread Starter
Join Date: Sep 2009
Location: NJ
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: I6 4.0
UCA bolts are worse... in my case anyway. Fuel line was too close to it and I ran out of gas so I couldn't torch the siezed bolt....
Short story, I couldn't install my CA drop and I still haven't found the time. Work sucks!
If only I could get paid to work on my jeep lol.
01-17-2010, 02:03 AM
#6
Junior Member
Join Date: Jan 2010
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
COAT/BATHE/WATERLOG them with pb blaster .... like everytime you get home spray them or maybe every time you get in or out of the jeep eventually they will losen up lol if that dont work....theres always cheater pipe or a hammer or a match lol
01-17-2010, 04:31 AM
#7
Newbie
Join Date: Mar 2009
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Year: 94
Model: Cherokee
Engine: 4.0
Dude was asking for help with a remote starter..
What make/model is the one you have? Here is an install manual for a ($40 cheap) remote starter I installed on somebody's jeep a while back:
http://www.mediafire.com/file/tetmj2...tecarstart.pdf.
The wire colors will be different, but they are all similar as far as which wires to tap into. That one took about two hours start to finish, taking my time.
Check out http://www.the12volt.com/, it's a great site for wiring diagrams and other useful info.
What make/model is the one you have? Here is an install manual for a ($40 cheap) remote starter I installed on somebody's jeep a while back:
http://www.mediafire.com/file/tetmj2...tecarstart.pdf.
The wire colors will be different, but they are all similar as far as which wires to tap into. That one took about two hours start to finish, taking my time.
Check out http://www.the12volt.com/, it's a great site for wiring diagrams and other useful info.
Thread
Thread Starter
Forum
Replies
Last Post
mattsmith
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
10-02-2015 04:46 PM
Cherokee_of_Tennessee
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
09-30-2015 12:10 PM
Dr.Capacitor
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
09-25-2015 03:02 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
