hey man i was reading up on that 10.25 rear axle swap into a Cherokee and it seems like what id like to do i don't mind doing custom fab, but i was wondering if you could help me out with a few things like, would i be able to put 4.11s or 5.13s in the axle, should i truss it, etc I plan on running 37x12.50x17 right now im 33x10.50x15 im just slowy building my Xj.

Another question for you man- Did you make your cross over steering? I remember you saying that you had the Currie (like me) and had some problems so you got cross-over. I am on the same page now. When I let off the gas with my stroker, my front end drops and steering goes nuts (y setup). Just wondering if you have any pics/build thread. Wondering how much this will set me back. Thanks again!

line locks

http://www.summitracing.com/parts/sbr-ll/overview/

Hey Atmos, I take it you quite a bit about the xj?!? I have a question...Are the drop brackets for the control arms bad or not dependable? When I got my kit from Rough Country, they did not recommend the long arm conversion.

Hey Atmos... I have a ? for you. I have the T&T stiffeners sitting beside me and I am still waiting to put them on. Would you advise cutting them to fit snugly around the sliders/subframe+long arm mounts or just attaching them to the stiffeners? Thanks man.

Hi! Atmos! I am New to the Forum. pisces3737 (Australia).

D30 seal replacement
http://www.naxja.org/forum/showthread.php?t=937821

cages
http://www.naxja.org/forum/showthread.php?t=1085950

cut and fold rear quarters
https://www.cherokeeforum.com/f58/re...rite-up-94546/

front dana 44 links
http://www.naxja.org/forum/showpost....38&postcount=3

full width stuff
https://www.cherokeeforum.com/f67/ax...5/#post1341715

Nevermind, just looked at your other photos. Sorry man.

Your profile photo is awesome... it sucks... but it's awesome. Was that a lucky photo op or was it your rig?

Happy Birthday!