ROCKRIDGE 4WD ROCKRIDGE 4WD is offline

Former Sponsor

About Me

  • About ROCKRIDGE 4WD
    Gender
    Male
  • General
    Location
    Wenatchee, WASHINGTON

Statistics

Total Posts
Visitor Messages
Total Likes
General Information
  • Last Activity: 03-05-2020 02:39 PM
  • Join Date: 05-05-2013
  • Referrals: 0

Social Profiles

Instant Messaging
Send an Instant Message to ROCKRIDGE 4WD Using...
Home Page
http://www.rockridge4wd.com
This Page
https://www.cherokeeforum.com/members/rockridge-4wd-78036/

Visitor Messages

Showing Visitor Messages 1 to 5 of 5
  1. ○|||||||○
    01-23-2023 10:56 AM - permalink
    Hi Erin,
    is the "50" Curved for either your XJ or ZJ and get 10% OFF and a set of mounts FREE!!"
    offer still available? If so i would like to order.
    Sincerely, ○|||||||○

  2. tymatt
    03-26-2014 09:11 PM - permalink
    Hey guys, my name is Jim. I ordered a 4.5 long arm Rough Country lift kit SYE and Dual steering stabilizer from you guys a few weeks back. Everything is fine with the kit except when I installed it, removal of my cross member resulted in three broken bolts out of four in my sub frame. It previously had a transfer case drop kit and I guess the bolts being rusty and extended because of the pucks they snapped without much force at all. but at any rate I've fixed it and have it installed and had it aligned. The problem I have now is a fairly serious case of bump steer. Do you have an affordable solution to my problem as in over the knuckle or the one ton steering I've heard of, witch is best? What would you recommend.
  3. rollingaddicton412
    01-31-2014 10:16 PM - permalink
    How much for a zone 3" lift with full leaf packs?
  4. tymatt
    01-24-2014 08:06 PM - permalink
    I didn't realize there was a place on this forum where someone could buy parts.I am looking to purchase a Rough Country 4.5 in long arm kit. My Cherokee already has a short arm 3 in RC lift installed but it rode so rough that it is actually tearing the lower control arm mount apart. The metal has cracked 75% around the mounting bolt. I have a some what limited budget, like a lot of guys right now are hurting in the money dept. but am forced to up grade. Welding would only be a bandaid and more damage is sure to occur. Ive been to there web site and seen what they have to offer. if interested in putting a kit together for me I would like to hear from you.
  5. Acerwin

All times are GMT -5. The time now is 07:32 AM.